Good RDA for mouth to lung hits?

[bholcomb22]

Hey guys,

I have been rebuilding for a while. Mostly in my kayfun lite. I got a stillaire clone dripper, and the airflow in it is intense! Super nice vapor production with a dual micro coil.

I find it pretty much impossible to hit it mouth to lung, and I just have to take big lung hits. I truly don't enjoy lung hits like I do a good mouth to lung just like on a real cig.

Are there any drippers you guys would recommend with good vapor production, but has the right airflow for mouth to lung inhales?

 

[Marc411]

Magma clone is real nice and has nice deep wells. A dual coil is a little bit of a PITA but the results are well worth it.

 

[bholcomb22]

Magma clone is real nice and has nice deep wells. A dual coil is a little bit of a PITA but the results are well worth it.

Looks like a good piece with a good airflow options. Thanks for the suggestion. It does look like dual coils would be a HUGE PITA. lol

 

[Marc411]

I have the clone and the original and I will tell you to buy the clone, no big differences and you can find them for under $30.

I set mine up yesterday with dual .7 ohm and Strawberry Custard. It was a great vape. The build is a PITA but the vape is well worth it. If you do a search here you'll see it gets great reviews.

Good luck on your quest. It will become never ending ;-)

 

[tj99959]

I too want a good mouth to lung, BUT at least for me, that means less air flow, less air flow means more resistance, and if you want good flavor that means a smaller diameter RDA.

If you like your KF, you will find that a ~2.2 ohm coil in an A7 is quite similar to a ~1.2 ohm coil in your KF.
However you won't be chasing any clouds with either one.

 

[bholcomb22]

Thanks for the feedback.

Any more suggestions?

 

[xtwosm0kesx]

Thanks for the feedback.

Any more suggestions?

May be oversimplifying but couldn't you just shut down the airflow control on the Stillare until you get a tight enough draw for mouth to lung?

 

[bholcomb22]

I did try this, but even tightening it as much as possible it is really really airy still... I may just have to try that magma.

 

[xtwosm0kesx]

I did try this, but even tightening it as much as possible it is really really airy still... I may just have to try that magma.

Hmm, don't personally own a stillare, but given the design (not terribly different than my Quasar) you should be able to close down the airflow to the point where you cant even suck through it.

 

[bholcomb22]

Well, I just messed with the airflow just to make sure I wasn't just being an idiot yesterday lol. Even when I can barely even see a hole it is still to airy. I think I just need to get another RDA which is fine. This is still an excellent RDA, and I will use if I feel like blowing some big clouds...

 

[Cb3b]

Not sure if u found one yet, but I would suggest the trident which has multiple options for air hole size. Even on some of the larger ones I am able to use mouth hits as long as it's burnin good. Also, I have noticed that different cotton amounts/widths can have an effect on on the drag resistance.