Got an eVic VTC Mini but the eGo One Mega tank is a buzzkill! Mod to increase juice flow or replace?

Status
Not open for further replies.

DoctorBuzz

Senior Member
ECF Veteran
Only way I can get juice to the coil is to turn the tank upside down, unscrew the tank from the base (where the air holes and atomizer are), then screw it back in.... and I get a few good hits. It's almost like a dripper with a tank. :-/

It's a little bit messier than that because a little juice leaks every now and again. No good!


Are there any mods to increase juice flow? Or should I just replace the tank with a Subtank or something else??
 

edyle

ECF Guru
ECF Veteran
Verified Member
Oct 23, 2013
14,199
7,195
Port-of-Spain, Trinidad & Tobago
Only way I can get juice to the coil is to turn the tank upside down, unscrew the tank from the base (where the air holes and atomizer are), then screw it back in.... and I get a few good hits. It's almost like a dripper with a tank. :-/

It's a little bit messier than that because a little juice leaks every now and again. No good!


Are there any mods to increase juice flow? Or should I just replace the tank with a Subtank or something else??

sounds like you are vaping a high vg juice at too high wattage, plus it's probably cold where you are, making wicking slow.
 
  • Like
Reactions: YoursTruli

DoctorBuzz

Senior Member
ECF Veteran
No. None of my juice is more than 50/50 PG/VG. it's only dropped below 50 deg F here for maybe 2 days so far this year. Even if it's been 75 degrees.... no flow. I have only used the Nickel coil that came with it.. and it was burnt in no time. I can't even find the box anymore to try the Titanium version. My dilemma is. . . .

Spend $20 on five Joyetech CLR coils and titanium wire?
... or Spend $40 on Subtank Mini, five OCC coils, and titanium wire?

I think I'll just switch to a Subtank Mini. People seem to like them quite a bit more....
 
Status
Not open for further replies.

Users who are viewing this thread