Got my first rebuildable, Taifun GT and it rocks!

[David Charles]

Well I'm about seven weeks since tobacco, had read all manor of stuff. I found the whole Puck site and built two actually (most parts came in pairs) and sorted making 3.0 ohm coils for the little pro tank style attys. (The Puck -4 AA batteries in my case- likes 3.0 ohm coils for battery life). Sorted that with cotton and was very happy, but wanted something more substantial. I was sold on the Squape, but the clones available were sucky so I found the Taifun GT which also allows you to remove the bottom without dumping your juice.

Anyway, got my Taifun GT clone yesterday. I did a couple of really terrible builds, spilled juice everywhere and was about to send the thing back or put it on ebay and then slept on it, watched another tutorial and paid very close attention to the drill bit size and the whole cotton installation bit. I finally sorted it! Built it this morning, have been vaping all day on my home made Puck and it's so cool and pleasant and absolutely no leaks if you build it right.

So the moral of my story is, if you're new and try a rebuildable and have a time getting it right the first time, don't give up! There is always a trick to it, in my case it was doing the cotton just right. Once you sort it you will have found the holy grail of vaping I expect, I am very happy I figured it out
and rock on all vaping peeps!

 

[prek2phd]

I was so proud of my first Taifun build. I started with the dreaded Squape, but that is another story. Congratulations!

 

[David Charles]

prek2phd, you'll have to tell us your Squape story.

 

[Asbestos4004]

Taifuns are great! They're the only attys I put a kayfun down for....plus, they look better on a provari than a kayfun does! I went from 4 kayfuns running to 2 kayfuns and 2 taifuns. A 1 ohm micro coil and some cotton....perfect!

 

[Snowdonia]

I got my Taifun GT a couple weeks ago and set it aside after some bad builds. Today I tried again and did it right, crazy thick clouds of tasty tasty vapor, I'm in love. Grats on your successful build!

 

[prek2phd]

I ordered a Squape from eciggity and I was blown away when I received it. I had watched several videos about the Squape so I figured I had a pretty good idea of what I was doing. WRONG! It constantly leaked from the air supply in the 510 connection. Even after I adjusted the cotton several times. Eventually, I plugged the air channel that sits just below the coils and converted the thing into a massive dual coil dripper, but I felt defeated. I picked up another Squape and had the same problems as before, but before throwing it into the trash I went to my local vape shop where they taught me to take softer and shallower drags. Now I live in a little place called Squape Heaven. The problem was not the device, it was me. Go figure.

 

[lavall39]

congrats on yor build it can be a challenge to get it right