Hard pull

Status
Not open for further replies.

Bman.

Full Member
ECF Veteran
Mar 13, 2009
53
0
49
Missouri
I noticed this morning on my way in to work that my drag was considerably tougher. Almost as if I had my thumb over the hole on the bottom of the atomizer (I didn't). The vaper was awesome but I am afraid this is going to burn out the atomizer.

I topped off the cart last night...starting puffing on it this morning. I have a TW901.

What would make one cart pull harder than another? Cart filler stuffing?
The same liquid as usual has been used so I am not sure where the change is coming from.

Bman.
 

smokum

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Dec 9, 2008
4,669
385
63
Ottawa, Ontario -CANADA-
Try removing your atomizer (separate from batt and cart), and blow through the battery end (make sure you have a tissue or paper towel under it) with a steady long pressure.

You'll probably find quite a bit of juice and gunk drop out. Wipe the inner shell of the atomizer casing and re-assemble (you may need to drip a drop or two of juice on the mesh again to prime it and not change overheating the coil).

I find I have to do this every so often with any device once it either starts getting tougher getting a pull on it, or if it starts not producing a satisfying vapor.

VapeOn,
Greg
 

smokum

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Dec 9, 2008
4,669
385
63
Ottawa, Ontario -CANADA-
There shouldn't be, considering the amount of water to the amount that would come out of the atomizer in comparison would be huge.

However, I'll say this...... aside from blow cleaning out the atomizer, for near 6 months of using, I have NEVER found a need to ever boil or any other cleaning method has been required. And from seeing other reports of short lived atomizers, I don't think I ever will.

VapeOn,
Greg
 
Status
Not open for further replies.

Users who are viewing this thread