has anyone tried a dual parallel coil build with 26g?

[smacksy]

I'm looking at a better vape than I'm getting with my current dual coil build with 5 wraps of 24g coming in at .2 ohms...The vape is lame and so is the flavor with 100% VG..
I hear parallel coils work better. But the holes are not big enough for 4 strands of 24g and I don't want to drill them out either. Can anybody recommend a build with 26g? Thx..

 

[Spencer87]

Might try 28 or 30. Or just buy a new set up on fasttech. I just bought a Zenith clone... heard It's amazing. Was 15 bucks

 

[stevegmu]

100% VG isn't good for flavor, but my guess is it is all about the clouds...

 

[Mikie]

.2 ohms? uhm.... somebody help this nice person please.

 

[smacksy]

I have two 26650 mech mods and two Provari's... I run a couple of R91's on the Provari's OK but sometimes I want to blow better clouds on the mechanical mods which are fairly new to me..Have both the 28mm Stillare and 28mm Tobh RDA's ..these are the RDA's I'm looking for a better build than I got in them now...appreciate the reply..

 

[smacksy]

By the way, Ohms law states my .2 ohm build only pulls 21 amps at 4.2 v..But I'm using a 26650 IMR battery rated at 50 amps, that's plenty safe with room to spare..my button doesn't get hot, my mod doesn't get hot, in fact I have to chain vape it to even get it warm...
No worries on safety, just need to figure out a better build...thx

 

[smacksy]

Well I found that a parallel 6 wrap on 3mm bit read .17 ohms on the meter for dual coils..
I was in for a nice surprise as this is one of the best vapes I've had yet dripping...not too hot, thick and flavorful with better than average clouds... This build uses a lot of juice, I think, because it covers more of the cotton in its longer length..just order more 26g as I am gonna stick with this build for awhile...

from Droid Maxx using Tapatalk

 

[Dirtball]

yea the only build i use with my plume veil is a single dual parallel coil set up great production great flavor. i use 26g wire 5-6wraps around the srew driver that came with it or my 2.4mm screw driver.come out to .3ohm.

 

[Garym93]

Well I found that a parallel 6 wrap on 3mm bit read .17 ohms on the meter for dual coils..
I was in for a nice surprise as this is one of the best vapes I've had yet dripping...not too hot, thick and flavorful with better than average clouds... This build uses a lot of juice, I think, because it covers more of the cotton in its longer length..just order more 26g as I am gonna stick with this build for awhile...

from Droid Maxx using Tapatalk

I do a similar build. I do 10 wraps on a 1.9mm ID and I get about .16-.18. It's a really nice build


Sent from my iPhone using Tapatalk