Have A Postless Deck? Get One Of These

Status
Not open for further replies.

r77r7r

ECF Guru
ECF Veteran
  • Feb 15, 2011
    13,653
    22,632
    Pa,LandOfTaxes
    I think it's cool. Vapers used to come up with ideas like that and we had fun trying them out. Ha, we spent a few months testing equipment to poke holes in a cartomizer. There was a fella up the road from me making dual battery mods before China did.
    It's probably hard being an inventor nowadays when your ideas are stolen quickly.
     

    bwh79

    Vaping Master
    ECF Veteran
    Verified Member
    Dec 11, 2014
    4,600
    6,643
    46
    Oregon
    So let’s see, first you use the gauge to measure the thickness of your post. Then, you put the wire through the corresponding slot, and cut to length. The slot, that you chose because it’s the same size as the post that you just measured. Why couldn’t you just use the post and stick the wire through it (no measuring needed this way, we know it’s the same size as the post because it is the post) and cut the end to length that way?
     
    • Like
    Reactions: stols001

    ShowerHead

    Ultra Member
    ECF Veteran
    Verified Member
    Feb 23, 2014
    1,087
    2,142
    Massachusetts
    So let’s see, first you use the gauge to measure the thickness of your post. Then, you put the wire through the corresponding slot, and cut to length. The slot, that you chose because it’s the same size as the post that you just measured. Why couldn’t you just use the post and stick the wire through it (no measuring needed this way, we know it’s the same size as the post because it is the post) and cut the end to length that way?

    Where's the fun in that?
     
    Status
    Not open for further replies.

    Users who are viewing this thread