Have i been attaching my cart to my atty the wrong way this whole time?

[dattmavis19]

I have a 510. I also dont have a camera, so i will try and explain this in ASCII. If ya looked at the atty from the side (and the tube wasnt there to block view of the wick) itd look kinda like this: /\ from one side and if you turned it 90 degrees like this: [] . and then the cart tip is kinda like (=) if the = was spaced farther apart.
should the flat sides of the cart, when attached from the atty, be seen(like you can see the one flat side, and both the curved sides from your POV) when looking at the atty from this: /\ side, or this: [] side?

Ive been doing it on the /\ side.

I hope this made sense to someone.

basically, i either have the cart on correctly, or need to rotate it 90 degrees in either direction.

 

[CBB]

| /\ | (|[]|) is good (|/\|) | [] | is bad.

Looking down from the top the flats should permit the bridge to stick up inside not hit the angles on the bridge.

 

[eyebrook]

Cbb sounds good to me , thats what i was told

 

[dattmavis19]

| /\ | (|[]|) is good (|/\|) | [] | is bad.

Looking down from the top the flats should permit the bridge to stick up inside not hit the angles on the bridge.

Ok, thats what i thought, it just looked like it might fit the other way too, but then again it also looked like it might hit the cart and melt. only reason i even questioned it, was i saw a thread at some point where someone said there was an outline in the atty the same shape as the cart top, and you were sposed to line the two up, and there is such an outline inside my atty(or at least it appears so) but mine doesnt line up when i put it on like i have been

 

[CBB]

You will know when you put one one wrong it will burn the edges of the cart where it touches the bridge.