Hello all. Need some advise DNA30 TOO HOT on display screen.

[jabber13]

Have a DNA30 ......... bought a Magma clone and using this combo for dripping. Coil setup ... kathena A1 26 Gage... dual parallel with 5 wraps. dna says 0.3 O's( but the display blinks on and off) ... V is 2.1 So with this setup, I try to drip and the mod displays TOO HOT. With ring holes open on both sides of the atty. WHAT should I do to get this to work???? Thought about removing one of the coils and see what happens. Need your thoughts and advise

 

[xtwosm0kesx]

Have a DNA30 ......... bought a Magma clone and using this combo for dripping. Coil setup ... kathena A1 26 Gage... dual parallel with 5 wraps. DNA says 0.3 O's( but the display blinks on and off) ... V is 2.1 So with this setup, I try to drip and the mod displays TOO HOT. With ring holes open on both sides of the atty. WHAT should I do to get this to work???? Thought about removing one of the coils and see what happens. Need your thoughts and advise

The DNA30 (authentic) is not designed to fire anything below .5ohms, so im surprised it will even fire (if it will).

I assume the temp message is due to the temp protection sensor on the board tripping.

You would be better served by building a higher resistance coil allowing you to fully take advantage of the power/voltage range of the DNA.

 

[Heespharm]

The DNA30 (authentic) is not designed to fire anything below .5ohms, so im surprised it will even fire (if it will).

I assume the temp message is due to the temp protection sensor on the board tripping.

You would be better served by building a higher resistance coil allowing you to fully take advantage of the power/voltage range of the DNA.

+1 plus the magma is an oven and will transfer lots of heat to the device... That's why the 510 is so long so u don't have to screw it down all the way flush so as not to transfer heat


Sent from my iPhone using Tapatalk

 

[MrPlink]

Try doubling your resistance first.
Clone DNA 30s CAN fire that low, but they won't regulate, so you end up with performance comparable to a lousy mech.
.6 will at least give you regulation and a little room for power adjustment.

 

[jabber13]

Thanks for your help. Had a dual coil setup, removed one of the coils which put resistances to 0 .6. And raised the atty up so it could cool some. It is working well now.