Hello need some help

[dankcloudz]

Hi first off id like to say im new and sorry if this is in the wrong forum
Soo im running the new xcube 2 with a black crown tank, i went to switch for a new coil and now nothing is working. Essentially it can read all of the coils around their correct ohms, I can adjust wattage and even fire the mod, and when I fire it says its working, counting the seconds as well as voltage used but the tank never fires or even heats up (even when it is reading the coils ohms correctly) ive cleaned all the connections, screwed and unscrewed the coil and tank to no avail.
if it helps im using vtc4s

 

[Sir2fyablyNutz]

Hi @dankcloudz and welcome to the forum. You might try taking the batteries out and replacing them. It's the same as turning the mod on or off, but it might reset something so that it works properly. Other than that...

bump for another opinion.

 

[dankcloudz]

I tried and nothing new, sucks cause ive had this for maybe 2 weeks

 

[Sikko]

Do you have another coil you could try? Or another mod you could try your tank on?

 

[dankcloudz]

all three coils I have used have the same problem, and ill be getting another mod to try it on tomorrow and ill update you guys when I can. so far i think its either my mod or a faulty 510 pin/insulator on my tank

 

[OldSalt]

What is the firmware version of your X-Cube? I've used version 1.092 and currently run 1.093. Neither displays 'working' when the firing bar is pressed in wattage mode.
The settings for your MOD would help well. What mode are you in? What's the power? Min, Soft, Norm, Hard, or Max? If in TC mode what temperature and temperature coefficient are you set to? Details as to which coil you are using would also be of assistance. It's hard to offer advise when we don't know these details

Update: Firmware version 1.093 for the X-Cube II does not seem to update atomizer resistance properly. I needed to pull a battery to get the 'New Coil?' question when I switched from the 0.4Ω coil to 1.8Ω coil while in TC mode. I was using a Stainless Steel coil. Version 1.092 handles this properly (I reverted to find this out)

 

[dankcloudz]

my apologies, by working i meant it was doing the whole second counter as well as volt meter (which happens whenever it fires) as well as the firing bar lighting up.
i run it often around 60w so nothing crazy, I never use tc just plane ol wattage mode. I usually run soft mode or norm mode, and the coils are the standard ones it came with, the 2x.025 and the .5. the problem occurred when i switched it to the last remaining coil i had (.25 dual). I was running 1.092 when it occurred, and updated to .093 which didnt affect it.
Also, my crown tank works perfectly on another mod so ive determined its the mod itself, to Oldsalt, the metal portion w/ the air vents where you screw the atty in appears to be ever so slightly twisted and I feel this may be the problem