HELP Gamma V2 clone broken 510 screw

Status
Not open for further replies.

BigCap

Senior Member
ECF Veteran
Jul 21, 2014
200
58
Earth
Hey guys, I am new here and I was wondering if I could please get some help/advice.

So I purchased a gamma v2 clone off of eBay. (My first rba) I noticed that the plastic piece on the bottom battery screw connector was missing a little chunk out of the side. I didn't think much of it, so I made a coil anyways, and it is reading 0.0 on my innokin vv3 (I don't have an ohms reader).

Now, I just took a screw driver and tried to loosen the screw, because it was clearly wedged in there. I hardly put any pressure, and a piece of the screw broke off!

So I am wondering if there is a replacement I can purchase from a hardware store or any advice. Btw, the box it came in was a blank black box with just a sku number on it. Nothing on the Internet about the sku number either, go figure.

Any help would be greatly appreciated. Thank you
 
Status
Not open for further replies.

Users who are viewing this thread