Help!!!!!!!!!! How an atomizer works

Status
Not open for further replies.
:confused: ok im using ikenvapes full size 801 atty on a prodigy v3.1 @ 6 volts from puresmoker. The problem that im having is with dripping. i have heard drip on the bridge, and also heard dripp down the inner wall, and even remove the bridge and drip directly on the coil. ive heard 3-4 drips and 7-8 drips on the 801. my question is how does the e liquid get to the coil? if i remove the bridge it just goes down the little holes the wires come into the coil, if i drip on the bridge it flows down to the sides and then in to the side holes of the cup and down the hole, if i drip down the inner walls it goes into the cup and down the holes. so where does the juice go how does it get to the coil. even with the bridge on, there is no wick on the ikenvape 801's. Also if i only drip 3-4 drops the coil glows red after 1 pull 3-4 seconds. if i drip 6-7 it gurgels like i over driped it. Please help what is the anotomy of an atty and how does the juice get to the coil after it enters the cup and goes down the whole??? :confused:
 

WomanOfHeart

Vaping Master
ECF Veteran
Sep 19, 2010
5,430
1,253
60
Colorado
The liquid makes its way down to the bridge and coil on its own. I also use the IKV 801s and I love them! I'll start with 7-8 drops and vape until the vapor starts dropping off and the flavor changes, then add 4-5 more drops. I don't take the drip tip off and I'll gently blow into it once in a while to help the liquid get down to the bridge. I don't recommend debridging these atties. They aren't designed for that and it might ruin them. They do take at least a day to break in properly and they do require a little more patience than 510s, but that's only because they are so much longer and bigger.

HTH!
 
Status
Not open for further replies.

Users who are viewing this thread