HELP!! I keep getting BURNT hits on NEW coils for the SMOK TFV4...

Status
Not open for further replies.
IM not sure if im not priming my coils right, but ive tried both the triple and the quad coils. i start the watts around 40 and ill get a couple ok hits and then ill get ....ty hits & wont be able to go above 50 watts... i prime it by keeping the coil in the little plastic package and filling it up with my ejuice and letting it sit overnight. i also pull the draw without firing the mod.

Does anyone have ANY IDEA of what im doing wrong or ANY SUGGESTIONS??

*THANKS :)
 

Douggro

Ultra Member
Nov 26, 2015
1,399
2,286
61
Seattle, WA
The TFV4 coils are rather large, so I would suspect that it takes a lot of liquid to get them properly primed. It's usual procedure to drop liquid into the top of the coil head and then let the coil soak in the filled tank for a while before hitting on it. Doing dry pulls with the airflow closed down should help - two or three good hard pulls.
 

crxess

Grumpy Ole Man
ECF Veteran
Verified Member
Sep 20, 2012
24,438
46,126
71
Williamsport Md
IM not sure if im not priming my coils right, but ive tried both the triple and the quad coils. i start the watts around 40 and ill get a couple ok hits and then ill get ....ty hits & wont be able to go above 50 watts... i prime it by keeping the coil in the little plastic package and filling it up with my ejuice and letting it sit overnight. i also pull the draw without firing the mod.

Does anyone have ANY IDEA of what im doing wrong or ANY SUGGESTIONS??

*THANKS :)

EVERYTHING!

You remove the Coil From the Package.
Place the Coil in the Base
Soak the top of the coil
Wait
Soak the top of the coil Again
Wait
Add another Few drops
Assemble the Tank
FILL the Tank
Sit the Tank aside for 15+ minutes

Air OFF
Draw
Repeat
Air Open
40W
Vape - 5-10 times
50w
Vape 5-10 times

Assess and continue

*Once Burned, a Cotton Coil is ruined - Toss it.
 
Status
Not open for further replies.

Users who are viewing this thread