hey, i'm trying to make my own tobacco pipe mod.
I am going to be using the auto switch out of a bloog battery to make it buttonless.
I'm hoping to be able to run an AW18350 without any issues with the switch.
That is the easy part.
Now for the issue. I have an old eGo pasthrough that i haven't used in a long time that doesn't hold a charge anymore.
I wanted to use the charging circuit out of the eGo. It is small and compact, so it could be easily fitted into the mod.
I'm not going to be too disappointed if i cant put the charging circuit in there, but as it was just an afterthought , i'm hoping i can get it to work.
this is how the eGo and BLOOG were wired up when i took them apart.
this is how i think the the two circuits should be used together.
it should be noted that the battery (-) and wire that goes back to the connector (ground) run off the same trace on the board.
if unnecessary i may eliminate that extra wire, or just keep it and reuse the solder points.
If anyone knows of a reason as why this wont work, or if i misjudged how this should be connected together, than please leave your input.
I will eventually bench test this setup, to see if it would fire up and charge.
But i like my facial hair and dont want to fry the boards accidentally.
Thanks for reading, and happy modding
I am going to be using the auto switch out of a bloog battery to make it buttonless.
I'm hoping to be able to run an AW18350 without any issues with the switch.
That is the easy part.
Now for the issue. I have an old eGo pasthrough that i haven't used in a long time that doesn't hold a charge anymore.
I wanted to use the charging circuit out of the eGo. It is small and compact, so it could be easily fitted into the mod.
I'm not going to be too disappointed if i cant put the charging circuit in there, but as it was just an afterthought , i'm hoping i can get it to work.
this is how the eGo and BLOOG were wired up when i took them apart.
this is how i think the the two circuits should be used together.
it should be noted that the battery (-) and wire that goes back to the connector (ground) run off the same trace on the board.
if unnecessary i may eliminate that extra wire, or just keep it and reuse the solder points.
If anyone knows of a reason as why this wont work, or if i misjudged how this should be connected together, than please leave your input.
I will eventually bench test this setup, to see if it would fire up and charge.
But i like my facial hair and dont want to fry the boards accidentally.
Thanks for reading, and happy modding
Last edited:
