Help on series box mod.

[RichardP]

Ok so I wanna build a box mod and I want it to be series. This will be my first attempt at building a box on my own, I plan on using a mosfet, simple switch, Hammond 1590B inclosure, Fat daddy 510 and 14G wire. Ok Im using "Round Dead Soft" wire is this ok to use or should I get a different type? And for the wiring ive looked a few wiring diagrams for a parallel box mod but I cant find one for series. How do I wire it for series?

 

[vinylsplinters]

I'm not sure on the Round Dead Soft, i just use solid copper 14G. Most people would recommend not doing a series for first build. if your using a keystone batt sled just short the lower terminals together then one of the top terminals is + and one -. I hook up the mosfet on the - side of the circuit(dont forget to add the 15Kohm resistor to mosfet). Be safe, over research, know the mods limitations. Not my diagram just found online. good luck!

 

[RichardP]

Thank you! ive had a series box and loved it, so I know a lot about the limitations and such

 

[Mooch]

Ok so I wanna build a box mod and I want it to be series. This will be my first attempt at building a box on my own, I plan on using a mosfet, simple switch, Hammond 1590B inclosure, Fat daddy 510 and 14G wire. Ok Im using "Round Dead Soft" wire is this ok to use or should I get a different type? And for the wiring ive looked a few wiring diagrams for a parallel box mod but I cant find one for series. How do I wire it for series?

Your round dead soft wire should be OK as long as it doesn't sag or bend over time. I haven't seen dead soft in that large a gauge so I don't know how pliable it is.

 

[RichardP]

Yea i have no clue of the difference in wires lol.