Help RDA Shorted
- Thread starter ballallday
- Start date
- th_trl_thread_readers 0
- Status
I'd say get closer to 1 ohm. That's gonna be a real sweet spot on a 30W device.
Nope, heat lowers resistance... just an observation from 20+ years as an electronics tech
My bad
the very distant and faded memory has apparently failed me.
My bad
LOL! Don't worry about it... if it happened last week, I've probably already forgotten it!
This sounds alot safer than pushing your mod to its limit. Or even over it's limit. BOOM!! Is no fun...
Yea im using the pre built coils it comes with and couldnt control the ohms. Now its only one pre built coil and reading .4 ohms
This is also why you should always check the ohms of a build with a multimeter or decent 510 threaded ohm meter before putting it on a mod, since a lot of mods ohm checkers are a bit wonky at the lower readings, and dont give you an accurate picture.
I have been pleased with mine from Lightning Vapes, they are my go too for all my Rebuildable needs;
Cartomizer and Atomizer Ohm Meter (Adapter separate add-on. Check the | Lightning Vapes
I do also have a very high end Fluke Multimeter, which I used a few times, but it showed me that the one I got from Lightning Vapes was accurate enough for the task of building coils.
It also makes for a great base, to put your deck on, while you build coils.
- Status
Similar threads
