Help required for Ti TC on Efusion..

[abesh]

Built my first TC coil with Titanium wire which came to 0.26 ohms. Loaded the Ti profile on the efusion, locked the resistance and fired. Set Temperature to 475F. Really nice warm and flavorful vape. However the screen flashes "Temperature Protected" after 2-3 draws and stops firing. I need to let it cool down for the TC to work again and then the same after a couple of draws. Same situation on my VT133 and my Therion.

Is this how it is supposed to be? What am I doing wrong? How can I get a consistent draw?

 

[TheotherSteveS]

what atty you using? Probably just a wicking issue and you hitting it too hard. What power you using??

Need a few more details to be really helpful..

Temperature protection doesnt mean its not working, quite the opposite!!

 

[abesh]

what atty you using? Probably just a wicking issue and you hitting it too hard. What power you using??

Need a few more details to be really helpful..

Temperature protection doesnt mean its not working, quite the opposite!!

Using a Petri clone. Preheat power set at 75W.

 

[sawlight]

Turn your preheat down to around 30 watts for starters, with 75w you may not be able to wick juice fast enough.

 

[abesh]

That makes sense. Let me try that Thank you!

 

[Car147]

Temp protection message is not something wrong, it's just telling you that your hitting the limit you have set. Drop the power or increase the temp making subtle changes until you find the setting you like.