Ok im in the middle of converting my phoenix bottom feeder into a genesis style atty...
I was going to use large ss needles for my pos and neg posts to run down the length of the inside of the tank- but the only needles I have left are too small.
I have some galvanized wire but since being a welder and knowing galvanized lets off some bad fumes when welded im worried about it being in contact with my juice.... any other suggestions? Im drinking right now so cant leave to go buy needles- I have lots of scrap drawers and boxes fulla stuff so need some ideas/alternatives that will be safe for juice contact
second question----- whats a good general width of ss 400 mesh to use for a wick before I cut it?
thanks guys
I was going to use large ss needles for my pos and neg posts to run down the length of the inside of the tank- but the only needles I have left are too small.
I have some galvanized wire but since being a welder and knowing galvanized lets off some bad fumes when welded im worried about it being in contact with my juice.... any other suggestions? Im drinking right now so cant leave to go buy needles- I have lots of scrap drawers and boxes fulla stuff so need some ideas/alternatives that will be safe for juice contact
second question----- whats a good general width of ss 400 mesh to use for a wick before I cut it?
thanks guys
