Help.. where to get Kayfun Center pin..

[xSoyer]

The bottom most screw on the kayfun 3.1 - I dropped mine down the sink yesterday while washing it, and had no luck retrieving it..

I see it on the svoemoesto german site, but not on the russian site.. The german site doesn't ship to the US as far as i can tell..


Am i screwed..?(no pun intended)

 

[SissySpike]

Try taking off the Ptrap under your sink chances are its probably still there. Thats the S looking pipe just below your drain. All you should need is a pair of channel locks,

 

[xSoyer]

Try taking off the Ptrap under your sink chances are its probably still there. Thats the S looking pipe just below your drain. All you should need is a pair of channel locks,

View attachment 274839

Thanks, i was told i can't do this because it would cause leaks.. due to caulking or something... i tried stringing a magnet to a hanger and sticking it down the drain.. but didn't get anything.. I'll have to try and remove the p-trap when i get home and just hope for no leakage..

 

[State O' Flux]

I doubt there's any caulk in modern p-trap joints... usually just plastic or rubber seals. If they're in good shape (not torn or degraded to crumbly chunks), you can reuse them. If it's a plastic p-trap with hand-tighten type nuts, you may not even need the channel locs.

 

[xSoyer]

I doubt there's any caulk in modern p-trap joints... usually just plastic or rubber seals. If they're in good shape (not torn or degraded to crumbly chunks), you can reuse them. If it's a plastic p-trap with hand-tighten type nuts, you may not even need the channel locs.

Alright, thank you

 

[Miralcos]

Is there still not a source for the pin? I need the pin and the adapter pin that it screws into that holds the positive coil block down also. Sux to be so clumsy.

 

[whatJD]

I need the "center pin" as well. Kayfun 3.1 Center Pin - Kayfun 3.1