Help with iclear 30s dual coil

[mrdfield]

Hi, Posted earlier but still confused i have a itaste VTR with a iclear 30s
Coil is 1.6 please anyone tell me the watts i should be using I have
looked up the ohm volts watts calculator but is no help this dual coil thing
is messing me up .I have a MVP 2 with a kanger protank 2 and according to the kanger
instructions i am running 3.4 volts on a 1.9 coil which equals 6 watts
how do i figure this out on my vtr with a 1.6 coil
thankyou

 

[State O' Flux]

Dual coil attys tend to work better with higher wattage/voltage than what a chart might indicate. Remember that charts and calculators are only guides - there are so many other variables that apply.
When I was using low resistance (unmodified coil heads) iClear 30s with an MVP2, and typically 70/30, light body and color juices, I ran in the 8.5~10 watt range... or, on occasion, 5~6 volts. The variable tended to be the juice itself that determined the best power application.

 

[EBates]

Try it at about 7 watts, take a couple of puffs, adjust up/down as required to find the 'sweet spot'.

 

[STEELRAIN]

It depends on the PG/VG mix. i run my higher PG at about 8W and my higher VG at about 10W. again your personal preference is where it is going to be at. but as a rule try higher watts.

 

[djsvapour]

I run 30S clearomisers 1 or 1.5 watts higher than all my others.

8.5 or 9.0 compared to 7.5 or 8.0.

 

[ethermion]

I burn 50/50 juice. 4.5 Volts or 9 Watts is about right for me on my 30S. I adjust up as the atomizer ages. Spin the darn thing from time to time to make sure the atomizer stays wet. Just tried 3.6V/6W. Yuck. Turn up the power.

 

[Keeferes]

I personally enjoy most all of my juice at about 6 watts. Right now my strawberry from jj vapers is best at 5 watts. That's on a 2 ohm 30S, VTR, 50/50, 24 nic.

Sent from my SCH-I535 using Tapatalk