Hi folks, Jax here. Not much of a blogger but in need of your wealth of knowledge. Just switched 1.2 head in new subtank and now my dna30 wont fire. It says check atomizer, although it was working fine till the head swap. My mini nautilus works in dna and subtank fires in several other mech mods. I tried 3 different new and the old head and still no love in dna30 so it has to be the tank. I unscrewed head and it was a bit wet in the base, not a great seal I think, but I dried it to no avail. The pin is not stuck, the negative threads both tank and dna30 are clean and dry but it just aint working. Any thoughts? Also, new battery in mod which again is working with my mini. Much thanks!!!!
Help with Kanger Subtank, and hello all!
- Thread starter jaxst
- Start date
- th_trl_thread_readers 0
- Status
Welcome!
Just wondering: are you putting in 1.2 ohm occ coils in place of the old 1.2 ohm? And you are sure the new coil is good? Reads good on another mod?
I find juice in the base on mine as well....lots of it. Less if I let off the fire button sooner and keep drawing for a second after.... otherwise I get vapor out the air holes and juice in the base.
Just wondering: are you putting in 1.2 ohm occ coils in place of the old 1.2 ohm? And you are sure the new coil is good? Reads good on another mod?
I find juice in the base on mine as well....lots of it. Less if I let off the fire button sooner and keep drawing for a second after.... otherwise I get vapor out the air holes and juice in the base.
Thanks for reply and yep, three new heads including the bad tasting one that worked fine before I removed. Tried them all and nada on dna30. They all work on my mechanical though. Weird, what happened to the functioning on the dna30? Currently vaping nautilus mini on dna just fine. Perhaps kanger pin just barely reached positive connection on dna and now is dirty, thus not extending usual extra milimeter?
I seem to remember reading "somewhere" here that the spring loaded pin on the subtank, combined with the spring loaded pin on a mod created issues... dunno. Hasn't happened to me. The mod I am using has a spring loaded pin, is a kanger mod, and is working fine with subtank.
Good luck, I hope you get to the bottom of it and get back to vaping.
Good luck, I hope you get to the bottom of it and get back to vaping.
Oh boy me too, thanks. btw my dna30 isnt spring loaded and the tank now has worked on two spring loaded and one non spring loaded mech mods. Pin looks clean and fully pushed out, still getting check atomizer. Not so stoked on this tank....my atlantis still works great though.
- Status
Similar threads
