Help with oddy clone and/or ithaca clone.

Status
Not open for further replies.

Surgical

Senior Member
Verified Member
May 25, 2013
72
50
San dimas CA
So I bought both oddy and ithaca clones from fasttech, and im having lota of leaking. I honestly dont know if im doing something wrong, but no matter what I try, im always getting juice into my mod on both attys. The only time I get a good hit is after all the juice has drained out, and I get two good hits then dry hits. Ive searched through the forum but havent found the solution.

Sent from my SCH-I545 using Tapatalk 2
 
Yes that's the center part, that whole assembly which screws down on the base... make sure the o-ring at the bottom touches the base before securing the ring at the top which captures the negative wire.

And yes, its reliable as the real thing. ^^ got both. The engineering (Imeo's), is undoubtedly one of the best silica tank systems out there.
 
Last edited:

Chris6204

Full Member
Verified Member
Jul 3, 2013
45
25
USA
What birdiebogey said. Also on the Fasttech Ithaca I got the "basic feeding piece" (go to Clouds of vapor website in the Ithaca parts section to see what the basic feeding piece is) did not have a washer on it. Once I used a washer on the basic feeding piece and did what birdieboogey described I had no more flooding, leaking or gurgling.
 
Status
Not open for further replies.

Users who are viewing this thread