I never had an issue with my EM attys. I have some that are over a year old. I am going to try to rebuild my HH 357. I ordered some of the materials the other day. It's worth a shot,
HH.357 stuff
- Thread starter sjoat
- Start date
- th_trl_thread_readers 0
- Status
Yeah 357s are awesome. I like hv vaping so I have been vaping my 3 ohm at 6v almost exclusively since December. The performance finally started to drop this month so I just got a Cisco 510 1.5 ohm to hold me over till I get my grand vv, and a hh357 2.5 ohm long barrel. This is my first long barrel, and I hope I like it. I find the 357 doesn't always spit for me, but when it does it's terrible. I had most recently been using it with just a cherry vape universal with out another drip tip attached and I love it, thats why I went for long barrel. Worst case scenario I will take the long barrel tube off and put a short on (I have had one apart many times before and successfully put it back together)
-Sam
-Sam
I am going to have to try an HH 357. I really like the i06 from ikenvape. That's the atty I use on my Reo Grand. The only complaint I have is the special drip tip you have to use with it.
GratefulVaper carries an i06 sleeve that allows you to use whatever 510/901 drip tip you prefer to use.
my shorty 357 2.0 died today after about a week and a half of use. It was flooding into my catch cup on the Reo. Every time I squeezed juice into it, it came flooding out into the catch cup. As soon as I put it on this morning it was having hit and miss burn tastes. I think I may have soaked it too long in pga (I do that!) Left it soaking overnight (3rd time, just forgetfulness). I must have dissolved an important piece inside that helps keep the juice from leaking out (all I can think of) before it died, I slammed it on the table 3 times (on the drip side) and that actually repositioned the insides about a quarter inch or more up towards the drip tip. Took a couple more hits....death! I opened a ticket at Avid to hopefully have it fixed.
On a better side my long barrel is still performing nicely (cleaned the same way, with forgetfulness) It's probably due to react the same way shortly....you think?
On a better side my long barrel is still performing nicely (cleaned the same way, with forgetfulness) It's probably due to react the same way shortly....you think?
I've forgotten mine soaking overnight a couple of times. Mine survived. I'm not sure if the casing and the atty is just pressed together or if he uses any sort of a glue or bond. MWA has mentioned taking his apart more than once, so I'm left with the impression if something like that happens, a person should be able to press the tube back on to the guts to stop the leaking.
- Status
