High-airflow RTA in BLACK

Status
Not open for further replies.

Treeburner1983

Reviewer / Blogger
ECF Veteran
Verified Member
Recently I've picked up a few TC mods (2x Waidea VF V3 clones, 2x ipv4) and one of each is a black mod. However, my favorite tanks for TC, the Youde Goliath and the eleaf Lemo 2, both are only available in stainless finish.

So I'm looking for an RTA that's available in black - I prefer lots of airflow, and won't consider anything with less airflow than the Lemo 2. Wish they were making the Goliath 2 or the Billow 2 in black, but looks like no such luck.

Any suggestions for a high-airflow RTA that works well with TC and most of all is available in black? Already have the original Lemo and drop in black, so looking for something else.

Thanks,
Treeburner
 

Treeburner1983

Reviewer / Blogger
ECF Veteran
Verified Member
Thanks! Been trying to get my original Lemo to work but with a 9 wrap 26g 3mm id ni200 coil the resistance is bouncing between 0.14 and 0.20 ohms when it should be around 0.08 ohm. Tried tightening all of the 510 adjustments but no matter what I can't get a solid resistance reading.

So there's a black subtank coming out, how about a dual coil rta with lots of airflow and a black finish?

Thanks,
Treeburner
 

tehmidcap

Super Member
Verified Member
Mar 13, 2015
370
143
PA
Black silverplay (tobeco or FT)
new Subtank mini plus
Black goblin (Ft or focal)

I also have two black goblins coming from focal that still haven't shipped after 10 days, but I might just sell them since I'm content with my silverplay kayfun 4hybrid -- something you could do with black kf4 and silverplay but you'd be spending close to $40. Awesome setup though.

A lot more color coordinated options in drippers, unfortunately.
 

Treeburner1983

Reviewer / Blogger
ECF Veteran
Verified Member
I found the authentic Silverplay with kayfun glass and chimney to be more trouble than it was worth trying to fill. The gasket for the glass blocked the fill port so had to top fill, which tended to make a huge mess each time I filled. Once I blew out the flooded airholes it would work great, but I like to be able to fill without needing 10 paper towels to soak up juice. Maybe mine just sucked, but so much happier since I boxed my Silverplay and picked up the Goliath!

-Treeburner
 

tehmidcap

Super Member
Verified Member
Mar 13, 2015
370
143
PA
I don't have trouble.. I either close airflow then top fill while holding at a slight angle opposed to straight up and down, then do the trick of turning upside down after tightening the top nut half way... I've had virtually zero leakage the past three days that way. You can also just stick a needle tip into the evap chamber holes.
 

Treeburner1983

Reviewer / Blogger
ECF Veteran
Verified Member
I wasn't using a k4 tank, was using the regular kayfun quartz kit from FT. Unless something new comes out in black in the meantime think I'll wait for the black Subtank Mini, as the RBA deck works great for TC on my fiancée's Kangxin VF Mini.

Thanks for all the suggestions!

-Treeburner
 
Status
Not open for further replies.

Users who are viewing this thread