RTA for Temperature Control

[a tez]

Does it leak when you top fill it like riptrippers said it has been for him. Been curious about that and been waiting for his review before I order one.

Also, been successfully using my lemo drop with TC. At first it was reading the ohms very high but I tightened it up and it's working great now.

No, only if I over fill it then it will leak.

When filling, close off bottom airflow first. Then open the fill port. Fill the tank with juice until there is about 10% empty space in the visible glass. Don't fill the tank all the way up to the fill port. Close the fill port and then open the airflow. Vape away!

I haven't had it leak once when using this method and I have put close to 35ml (or more) through it so far.

 

[Adrian Ludvik]

No, only if I over fill it then it will leak.

When filling, close off bottom airflow first. Then open the fill port. Fill the tank with juice until there is about 10% empty space in the visible glass. Don't fill the tank all the way up to the fill port. Close the fill port and then open the airflow. Vape away!

I haven't had it leak once when using this method and I have put close to 35ml (or more) through it so far.

Thanks. Good to hear because the top fill looks super attractive.

 

[a tez]

Thanks. Good to hear because the top fill looks super attractive.

It is great. Super convenient. I haven't touched any of my other tanks/RTAs since gettig the Lemo 2.

 

[TheotherSteveS]

It is great. Super convenient. I haven't touched any of my other tanks/RTAs since gettig the Lemo 2.

well its super convenient if you dont have to mess with the deck/coil and have to empty the tank to do so! As I have said elsewhere, I really think that is a poor design choice...

 

[a tez]

well its super convenient if you dont have to mess with the deck/coil and have to empty the tank to do so! As I have said elsewhere, I really think that is a poor design choice...

You can just pour it out of the fill hole or unscrew the top while holding the glass in place and pour it out from there. I've done it and it's real easy to do.

I'm filling up my tank more than I'm messing with the coil so it's really not a big deal.

 

[TheotherSteveS]

You can just pour it out of the fill hole or unscrew the top while holding the glass in place and pour it out from there. I've done it and it's real easy to do.

I'm filling up my tank more than I'm messing with the coil so it's really not a big deal.

I'm being a bit picky I guess but I was really looking at one of these for TP use where you might want to fiddle with builds a bit more often. Knowing its not so bad to drain is helpful though!! Thanks for that!

 

[ChrisCanal]

So just in the hopes of helping someone else out there, i thought i would post an update now that i have abit more experience with the different tanks and temp control. At this point i would say the Lemo 2 is my favorite overall. I also have had good luck with the Delta 2 and the Kanger Subtank Mini (once i fixed the issue with the center pin). The Delta has the most airflow, but a bit less flavor than the other two. The Lemo 2 and Subtank seem to have about equal airflow, but the flavor seems a bit better on the Lemo 2. The subtank is a much warmer vape though. I am debating whether or not to even attempt a nickle build in the original Lemo i have, as i have heard it has some troubles with resistance fluctuating. Maybe i will just build it and see how it goes. Hopefully this helps someone considering one of these, and these are just my opinions based on the vape i like.