How do i fix "atomizer low"

[Kprthevapr]

I would suggest buying a separate charger and a couple extra batteries. I usually go through 4 batteries a day, I use two mech mods.
Charging with the USB port isn't a good idea with a removable battery. Not only that, it takes way too long.
Where are you at so that we can make recommendations on where to find the proper gear
We were all beginners once too.

 

[MMcQ]

+1 to charging the battery fully. Also, is pico showing resistance before you attempt to fire it? I would try watching the ohms read while seating the tank to see when it starts indicating resistance ( and therefore a connection) and watch if it fluctuates when getting to where the tank is fully seated and cannot turn anymore. Sometimes the center pin on the tank can push the center pin on the mod down too much causing a reading of 0.0

 

[Stanceking]

It came back to work !! And i did not know that the fix is so simple .. i just put it on the charger overnight and when i woke up it worked just fine .. thanks for all of your help

 

[Kprthevapr]

It came back to work !! And i did not know that the fix is so simple .. i just put it on the charger overnight and when i woke up it worked just fine .. thanks for all of your help

Grab some extra batteries and you should be good to go. An external charger is also a good investment, get at least a two bay charger.