How do I know when to change an atomiser?

Status
Not open for further replies.

Susan~S

ECF Guru
ECF Veteran
Verified Member
Mar 12, 2014
16,937
11,693
68
Mpls/St.Paul, MN
I will change out my coils when the coils get all "gunked" up and the juice starts to taste bad.

The problem with letting juice sit for a long time in a tank with a coil that has juice that has been carmelized on the coil is that that burnt taste will leach into the juice making all of it taste bad.
 
  • Like
Reactions: Baditude

ddirtyvapes

Ultra Member
ECF Veteran
Jan 23, 2011
1,183
1,563
Portland, ME
Yeah, what Susan said. There's no single "right time" to change an atomizer or coil; it's really whenever it starts to taste bad or work poorly for your preference. Some people could probably stand a gunky atomizer longer than I can, and vice versa. You just need to figure out where your limit is on the bad taste and potentially harsh hit. When dealing with disposable atomizers versus RBAs, some people will only use one juice in a disposable and toss it when the juice runs out. I don't do this, but I'm just pointing out that there's definitely a range of what different people like to do with regards to replacing parts.
 

MaxwellPink

Super Member
ECF Veteran
I've only been vaping for a little over a month and a half, now, so my advice may not be that useful, but aside from a couple of 1.5ohm Kanger coils that I tossed because of chronic flooding, I'm still using the first attys I bought.

That said, I do swap them out when I change flavors, with the "dirty" ones getting a good soak in hot water to be reused later.

I guess I'll pitch them when they gasp their last breath.:rolleyes:
 

AXIOM_1

Vaping Master
ECF Veteran
  • Jul 6, 2015
    4,874
    12,939
    Pennsylvania, USA
    yeah and if you let your coils go for awhile you will definitely know when they need changed. It will taste like you lit a pair of dirty old socks on fire and are trying to smoke them. The taste is unforgettable and you will know when this occurs, trust me :)
    Yes, I have tried to smoke dirty old socks :w00t:
     

    RaisinDanish

    Full Member
    Aug 25, 2015
    21
    6
    33
    London
    Perhaps a silly question, but how do I know? I've got loads of tanks so each atomiser probably doesn't get that much use, but I'm never sure on when to change them!

    Just put a new one in one of my Nautilus Minis as a liquid I'd tried before seemed unusually harsh on my throat, but what's the best way to know when it's time to swap one?

    You will probably realise soon enough... The flavour and smoke will drop slightly as the coil junks up
     

    George horacek

    New Member
    Aug 25, 2015
    1
    0
    65
    I've only been vaping for a little over a month and a half, now, so my advice may not be that useful, but aside from a couple of 1.5ohm Kanger coils that I tossed because of chronic flooding, I'm still using the first attys I bought.

    That said, I do swap them out when I change flavors, with the "dirty" ones getting a good soak in hot water to be reused later.



    I guess I'll pitch them when they gasp their last breath.:rolleyes:
    I read somewhere that you weren't supposed to expose the atomizer to water. But this works for you? I'd like to try it.
     

    MaxwellPink

    Super Member
    ECF Veteran
    I read somewhere that you weren't supposed to expose the atomizer to water. But this works for you? I'd like to try it.

    Some may not like it. I haven't had any problems with the silica wicked Kangers, though. Just make sure to place them gently in the water, and that they are thoroughly dry before you use them again. I usually leave mine out for a day before putting them away. Two if it's humid. Cotton wicks may need longer, though.
     

    retired1

    Administrator
    Admin
    Supporting Member
    ECF Veteran
    Verified Member
    Apr 5, 2013
    51,190
    45,746
    Texas
    I read somewhere that you weren't supposed to expose the atomizer to water. But this works for you? I'd like to try it.

    I keep a "soaking jar" filled with water that used coil heads go into. Once there are a few in there, I clean 'em up, do a dry burn, soak again and toss back into the rotation. It depends on the type of wicking material the head uses, too. Obviously you aren't going to do a dry burn on coils that use cotton for wicking.
     
    • Like
    Reactions: MaxwellPink
    Status
    Not open for further replies.

    Users who are viewing this thread