how do you get the best flavor from your atty?

Status
Not open for further replies.

tayone415

Ultra Member
ECF Veteran
Aug 9, 2013
1,104
361
CA
I usually have a .1 to .2 ohm 24 gauge dual micro coil with cotton setup on most of my atties and i find that sometimes i don't get that much flavor. Does anyone know a good setup where you can get good flavor? or are there any tips on how to get better flavor from drip rdas?

Organic cotton has good flavor after the cotton taste disappears, or Japanese cotton is broken it, I find I get better flavor with twisted kanthal.
 

happydave

Ultra Member
ECF Veteran
Jun 2, 2013
1,580
684
United States
its possible that your over heating the flavor. i find i get the best flavor right around .8 ohms per coil.
3/4 wrap of 30 gauge kanthal A1 around 2 strands of 2MM silica wick. make sure you torch (butane torch lighter) the silica before wrapping your coil.
lots of people complain about the "flavor" of slica, torching it before hand will fix that.
if you don't already have a torch look for a "chef's torch" or if you want something smaller a "cigar torch lighter"
 

Domkayfunimous

Full Member
Jun 22, 2014
53
20
Ga
Coil position, ohms, single vs dual, air hole position, draw speed, mouthpiece material, battery, mod material, mod, wicks, atty and more come into play when talking flavor. My normal atty's have more flavor on the exhale than the draw, only one that's different is the Magma. The flavor from it kills my desire for any other atty!
Put in a good .33 ohm parallel single and be done with it!

I have since relegated all my other atty's to sleeper coils for when you need to blow flavorless clouds!
 

tj99959

ECF Guru
ECF Veteran
  • Aug 13, 2011
    15,116
    39,600
    utah
    I would remind you folks that this is the noob forum, and it's not OK to be suggesting the use of 0.1 ohm coils to someone that is still trying to figure out which is the positive end of their battery.

    To the OP, how about introducing yourself. How long have you been vaping, what kind of PVs do you use, what atties have you tried, what builds have you done?
    In other words, how about assuring us that you DO know which is the positive end of your battery!
     

    tj99959

    ECF Guru
    ECF Veteran
  • Aug 13, 2011
    15,116
    39,600
    utah
    Best flavor so far is from my Magma at 1.4 ohms at 12W

    10298934_702897249781695_3292210996554686295_n.jpg


    Note that the "troll" hasn't bothered with even a second post in the thread
     
    Last edited:
    I would remind you folks that this is the noob forum, and it's not OK to be suggesting the use of 0.1 ohm coils to someone that is still trying to figure out which is the positive end of their battery.

    To the OP, how about introducing yourself. How long have you been vaping, what kind of PVs do you use, what atties have you tried, what builds have you done?
    In other words, how about assuring us that you DO know which is the positive end of your battery!

    ive been vaping for around 4 years? started off with the ego-twist (who hasn't lol) then moved on to mech mods maybe a year and a half to two years ago. i have 2 nemis one brass and one ss, i traded around and sold/bought a few atties. some of the ones i had were igo-w, igo-l, omega v1, kayfun lite +, and i just bought the 454 big block atty. my friends vape as well so i tried a lot of atties. i only use mnke and sony vtc4 batteries and i usually build dual nano, micro, and macro dual coil builds. occasionally ill build a quad, or parallel, but it eats up too much juice. I can assure you that i know which end is the positive end of my battery.. haha i just made an account so i have to post 5 new member threads before i can post normal ones.
     
    Status
    Not open for further replies.

    Users who are viewing this thread