How low is 10% ?

[tyrone747]

I notice the manual says the cartridge needs to be at least 10% full for it to function properly and not burn out your atomizer. What level do you guys go by? A large portion of the cartridge is inside the cone so you can't see how much is really left. Or do they mean 10% of the visible portion should be full? Thanks.

 

[patkin]

I've never found it to be a problem nor have I ever burned an atomizer. What I do is, when I can't see any juice holding it like a smoke, I turn the led end to the ceiling and flick the thing... ya know with middle finger and thumb flick... you'll see any juice fall down then. If there's none there or just enough left to see only a little coating of some color, I fill. There's usually some in the atty chamber left then to keep the wick wet enough not to burn.

 

[Andy Morris]

You can usually tell by either a lack of taste or a bit of a nasty taste, They are not like cartomizers where one dry hit knackers them for good. the eRoll atomizers recover fine once they get some juice.

Theres always a bit of juice sticks in the top (mouth end) of the chamber by surface tension.

 

[rico942]

I try to use the eRoll the same as the gas tank in my car, run on the top half ...