• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

How - technical

Status
Not open for further replies.

VapGeek

Senior Member
Verified Member
Oct 11, 2015
213
114
47
Local
DSC_0023 - Copy.JPG


Kanthal 24G 10 wraps (0.4Ω) @ 55W (152 mW/mm²)

Tried this for two days. Did not find very much different from 28G 10 wraps except that it draws a lot more power 55w to get the same amount of heat and the tank get much hotter. For me, I rather stick to the 28G.
 

cloudysheep

Account closed on request
Oct 5, 2015
849
635
behind you
Mostly is cause i have not gotten the rba for my tank yet and yeap i wanna change flavour is there anyway to wash the occ?


Sent from my lovely vape heaven
You probably can dunk them in water and burn off the remaining flavours if it wasn't a creamy based flavour. But don't burn the water all the way lest you burn the cotton aswell, burn thru the cotton then prima with the new flavour?
 

VapGeek

Senior Member
Verified Member
Oct 11, 2015
213
114
47
Local
Mostly is cause i have not gotten the rba for my tank yet and yeap i wanna change flavour is there anyway to wash the occ?


Sent from my lovely vape heaven


My method used: SOAK in Hot water to remove flavour (do not run water thru the OCC, so as to keep the cotton as intact as possible, 'a bit more cautious'), use kitchen tissue to go thru the coil to remove as much moisture as possible, then natural air dry. Do Not Dry Burn.
 
Status
Not open for further replies.

Users who are viewing this thread