How to: MAP Tank
- Thread starter Bigbuyer
- Start date
- th_trl_thread_readers 0
- Status
Thanks Bruce.... I was going to try to make one of these videos. I do do it a little different but, your way does seem to be the best as mine could cause damage to the tank if not using the care I put into it. So I decide not to show my way as other could cause some damage to theirs.
I enjoyed the video!
I enjoyed the video!
great video, I do hope that mine comes out as easily as you make it look! I dont have a dead battery to use for this so I hope that I dont trash a batt in the process.
I've had my map for a couple weeks now and it is still going strong on the original ce2. MAP TANK ROCKS!!!
I've had my map for a couple weeks now and it is still going strong on the original ce2. MAP TANK ROCKS!!!
You know, seeing that, I would be really scared to brake the glass top of the desk. LOL.. (it would happen to me)
Also, my desk is the crappy particle board and already chewed up.
I tried that a month ago when I asked Bruce how to get the CE2 out and he told me this way, I now have a chunk out of my desk, small but still not good.
Thats why I used my channel locks and the CE2 was bad anyways. Just replaced my burnt out CE2 with the last one I have (2.4) and this is very nice on 3.7v. Now, China better be sending these CE2's to Bruce or I'm in big trouble.. LOL..
Great Vid Bruce!!
Also, my desk is the crappy particle board and already chewed up.
I tried that a month ago when I asked Bruce how to get the CE2 out and he told me this way, I now have a chunk out of my desk, small but still not good.
Thats why I used my channel locks and the CE2 was bad anyways. Just replaced my burnt out CE2 with the last one I have (2.4) and this is very nice on 3.7v. Now, China better be sending these CE2's to Bruce or I'm in big trouble.. LOL..
Great Vid Bruce!!
I finally had to replace the ce2 and it was easier than I thought it would be! I did it just like BB did in the video, on the side of the table and bam... popped right out. AWESOME!!
<---- serious map fan here... LOVE THEM!!!!
<---- serious map fan here... LOVE THEM!!!!
Thanks for the video! Have been using mine for almost 2 weeks now and loving it!
Yup, did that with my second map tank, and wham it was out.. I would however add that this method is only needed the first time. Now I can just screw on a 510 battery and wigggle the ce2 out without any problems whatsoever.
ok took apart my tank to clean,used the table method as bruce . no go. really, really, stuck. so here is what i did. took a piece of wood,drilled a hole in it big enough for the ce2 to pass through. set the bottom bushing on top of the hole. with a nail set and a hammer tapped on the inside of the ce2, on both sides and pop! came right out. now understand i destroyed the ce2 in the process but if its burnt out and stuck works perfect.
- Status
Similar threads
