How to refill a joye510 cartridge??

Status
Not open for further replies.

Elendil

Assclown Exterminator
Supporting Member
ECF Veteran
Verified Member
Mar 28, 2009
10,413
678
IL USA
Either just drip the liquid right on the cart filler material

or

use a syringe to "inject" the juice down the side of the cart

or

get something called a needle tip oiler. It looks like this:

NEX1106.jpg


you can buy them here: Precision Oiler - Needle Tip Oiler Bottle 1/2 oz. - eBay (item 350217627995 end time Jul-24-09 11:01:13 PDT)

you get the advantage of a syringe but don't have the muss or fuss..............
 

JustJulie

CASAA
Supporting Member
ECF Veteran
Verified Member
Jan 30, 2009
2,848
1,393
Des Moines, IA
I just bought a Yeti and was wondering if you could pull the wicking material out of the catridge and drip the juice onto it that way. Seems like you could get a more even distribution of fluid.

My problem is that when I push the filler back in, liquid oozes everywhere. 8-o

I typically drip a few drops on top of the cartridge, waiting for each drop to be absorbed before I add another one. If liquid pools on top, you've added one drop too many. :)

To get better distribution without using a syringe, you can push the filler all the way down in the cartridge with tweezers, add some liquid on top, then pull/push/pull/push the filler (manipulating with the tweezers). That gets liquid all the way at the bottom of the filler. Then add a few drops on top to finish off.

I tried using a syringe but felt too much like a junkie. :oops:
 

NPerez

Full Member
Jun 9, 2009
63
5
36
Northern NJ
I usually take a sewing needle, use it to pull out the filler-material (most of the way, but I don't pull it all the way out), and I just soak it that way. easier to get it done thoroughly, little to no juice on my hands thanks to the handy needle, and I rarely overfill.

Like this:
picture0003myz.jpg


Obv any needles that go poking around in there need to be very clean
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread