How to test Ultrasonic Activities? it is here

[pcman2k]

Hoping you are all vaping well, and vaping on.

I am using the ultrasonic, in cleaning, and steeping. it is really important tool in vaping activities.
so ..... it was a question came to my mind, and had to dig for an answer,

how can i know if there is ultrasonic waves in my device? or it is just vibration?.

well, the following 3 links will answer this question in very easy way:
1- very simple very easy domestic aluminium foil test.
2- Other way of doing the same foil test
3- very useful FAQ

i took a deep breath after i did it and gave me a positive result of my device.

some notes:
it all depends on the power of your device, if you run the test for 1 min, you some minor needle holes in the said foil.
if you run it for 5 min you will get more needle holes in the foil.
finally, if you run it for 20 min you will have a big hole in the foil sheet even double layers like what i did.

i wish it is useful and helpful. enjoy vaping

NP. i searched several times for the same in the forum with no results, however, hopefully it not repeated.

 

[rowdyplace]

Good post.

Too many folks buy the low-low end unit and expect miracles. Then, when there is little to no effect, they quickly bad mouth the process.

The aluminum foil test does not lie!!

 

[DaveP]

I went through the same thing when I bought my low end Harbor Freight ultrasonic cleaner. The foil test showed pinholes, then more and large pinholes, then finally a few large holes in the center of the foil. That was when I discovered I needed to have my ecig parts suspended in the center of the vessel or sitting on a plastic table in the water and not laying across the bottom where there was little action.