SO I purchased an I-atty and it worked for a whole 6 hours. The first coil was a 3 coil (3-wraps) tested @ 1.1ohms and worked fine on my MVP. The coil popped about 6 hours later, not sure why. I went to use it and it just didn't work. I tested ohms on the MVP and read NON. I went home and built a new coil as seen in the pics above. I actually built about 3 but this was the best and read 1.6 ohms on my commercial electric meter. When installed on my MVP, the ohm meter reads NON. When put on my ego twist 1000 it fires but barely (the ego battery is near dead and charger loaned out). After I took the above pics, I made a new coil. I wrapped the s*#! out of the mesh (a lot of wraps) 32ga. I connected the terminals and tested resistance at 7.8ohms with my meter. I removed a couple coils and reconnected the terminal. I re-tested @ 5.2ohms. I did this until I tested the coil at 2.5ohms. I cleaned everything up and installed it onto the dying ego batt. and it fired. The MVP would still not register the resistance of the coil. My other clearos all work fine on the MVP. I'm going to go down to the shop tomorrow and see if it'll fire on a 3.7V mech mod. and possibly acquire some new hardware... we'll see how it goes.
