I cannot build anything

[gel drops]

I'm rolling in the floor...shame on me!

 

[USMCotaku]

:::Shakes head sadly:::

Sent with one hand, the other is busy vaping.

 

[gel drops]

Billow,deck quite a few options there.

 

[gel drops]

I think this will be very ..I suppose it depends on my building qualities..

 

[gel drops]

Game on...

 

[USMCotaku]

With these new sub tanks, I've lost my desire for new tanks
Sent with one hand, the other is busy vaping.

 

[gel drops]

With these new sub tanks, I've lost my desire for new tanks
Sent with one hand, the other is busy vaping.

honestly I have to no more projects in the near future my plate is full..

 

[USMCotaku]

Don't know what this coil is really called, but it looks like anchor chain, so that's what I'm calling it.... Made it tonight playing around, came out pretty good....

I twisted 24 and 28 gauge together, then cut that in half and twisted those together. Comes in around .2 ohm.
Works good, really sucks the juice

Sent with one hand, the other is busy vaping.

 

[gel drops]

Lemo,my glass replacement tanks arrived,26 gauge K about 10 wraps around a 3mm ps came out to about 1ohm,wick then liquid and I will be happy apologize for the bad pic.

 

[gel drops]

T8 went south on me,put it on the Lambo perfect match.

 

[USMCotaku]

I've discovered I like a higher ohm macro coil in my full size sub tank over the .5 ohm builds. I'm using 26 gauge kanthal, 10 wraps, squeezed tight, comes to 1.2 ohms. At 25 watts (the same wattage the sub ohm was at using 4.2 volts) I'm getting a cooler vape, with lots more vapor. I can run it up to 30 watts and get the warmth back...... With lots of vapor
Then I found out that the sub tank mini using the rba built at .5 ohm with 24 gauge kanthal is a perfect match with my mech, so it's out of partial retirement (was only getting used for the occasional dripping) and back to daily use
Sent with one hand, the other is busy vaping.

 

[gel drops]

No dry hits at all from the Lemo,flavor is off just a little bit,wicking issue also going to raise the coil just a little,26 gauge is about the maximum that I can use because the post screws on the deck are so small.I got to thinking the draw was tight so i took the bottom cap off..no wonder i was chocking it off,i opened the air flow wide open and boom this joker will fog up the room...

 

[gel drops]

I am going with 28 gauge next time 26 is extremely hard to work with for me.

 

[gel drops]

Reading .9 ohms on the lambo,not exactly accurate close enough.

 

[USMCotaku]

I am going with 28 gauge next time 26 is extremely hard to work with for me.

I love working with 26

 

[gel drops]

I love working with 26

I do to it's my favorite I was just referring to Lemo..

 

[USMCotaku]

Ah, ok. I usually use 28 gauge in my kayfun
Sent with one hand, the other is busy vaping.

 

[gel drops]

Ah, ok. I usually use 28 gauge in my kayfun
Sent with one hand, the other is busy vaping.

I have a mech mod that requires both hands..not sure how you're pulling that one off!

 

[USMCotaku]

Hah, that's nothing.... I've been using Clapton coils 28 gauge wrapped with 32 gauge on my kayfun lately..... Now that's a challenge
Sent with one hand, the other is busy vaping.

 

[gel drops]

Today i am going to experiment with a coil that's going to hit hard it's called Daytona 500....