I finally get the mech attraction

[rastapete69]

My mech mod journey began yesterday when I returned my first mech mod that had a short in the firing switch that was burning my finger and brought home a sigelei Silver Dragon.

i had been using an Igo L on my MVP2 and liking it at 1 ohm single coil but not as much as my Kayfun Clone.

Putting it on my mech was giving me the same results and I was wondering if my new mod would do more than make my Kayfun match better.

i carefully wrapped a dual coil and wicked with cotton and it read .4 ohm so I somewhat nervously went into my first sub ohm journey.

i am sure my build will improve but the coils looked even and were glowing from the inside out, so I felt confident.

i am very impressed with the amount of vapor I immediately got and feel a sense of pride and gratitude for the confidence I got to try this with the knowledge I gained here

 

[CreepyLady]

Nice work! Vape safe

 

[crxess]

Nice to know you can, even if you never have to.
Congrats.
Next learn a bit about the mechanics. Your other Mod should have been a simple fix. Once you have this down, a Vapocolypse will not stop you.

 

[deanthemachine]

Loving it myself. I did all my homework on batteries, electricity, ohms law, hotspots, shorts, ohms checking. Even keeping it at .8, I was nervous taking that first pull. I figured even if I don't like it I have a better understanding of electricity should I decide to rewire my house.

 

[Tbev]

Way different electricity bud.... But welcome to mechs, I stepped in myself and fell down a rabbit hole that keeps going and going, get a genny see where that takes you...

Sent from my Transformer TF101 using Tapatalk