So i built "the puck" today but with a 510, and its not working. Im not sure if its cuz i followed the tut for a 901 but its not workin, ive rewalked my steps, made sure the wiring was right and all. Im using a 510 to 510 extender with the postive wire on the middle post, and the black wire on the outside, maybe one of yall or the creator can help me out. plz and thanks
i habe no idea whats wrong
- Thread starter spc_erp
- Start date
- th_trl_thread_readers 0
- Status
If you can get 5 posts in here and wait for the system to update you can go over to the modders forum. Those guys will be able to help you.
Yeah, this will get moved there I'm sure.
Do you have a multi meter?
Check voltage at the atty side of the button to ground with button pressed. Get volts?
Check voltage at the connector.
Pull the batteries out. Check continuity on the connections (you probably have a hollow solder joint somewhere).
While you're at it, make sure you check that there's a manual on-off switch and that it has continuity when on. Also make sure you seal the atty connector inside with epoxy or some such so that it is juice-proof.
Do you have a multi meter?
Check voltage at the atty side of the button to ground with button pressed. Get volts?
Check voltage at the connector.
Pull the batteries out. Check continuity on the connections (you probably have a hollow solder joint somewhere).
While you're at it, make sure you check that there's a manual on-off switch and that it has continuity when on. Also make sure you seal the atty connector inside with epoxy or some such so that it is juice-proof.
- Status
Similar threads
