I have to drip every three hits?!
- Thread starter proudrookie
- Start date
- th_trl_thread_readers 0
- Status
It could be that you've packed the coil too tight with cotton but we would need some more info:
1) Coil(s) resistance.
2) Wicking method and materials.
3) Equipment that you are using.
But on the whole yes you will need to re-drip fairly often.
1) Coil(s) resistance.
2) Wicking method and materials.
3) Equipment that you are using.
But on the whole yes you will need to re-drip fairly often.
I'm currently using the Shiseido pads and I'm at 1.1 ohms. It's a trident rda on a Nemesis mod using 18650 mah efest battery.
Yes that's what I thought.. I find I have to put it down and take a few minutes in between hits to not have to drip every two hits.
2 or 3 seems a little low, on my MutationX I usually get at least 4-6 draws before having to drip again. But like Sarin said it can be multiple factors, some pics would help a lot. 
You could always get a REO
I'm glad someone else said it, cause I sure was thinking that but trying to refrain from enabling.
In my rda's, vaping around 0.9ohm, I can get a good 10-15minutes from 10-15 drops of liquid. Can you post a pic of your build, with wicks in place? Are you using a lot of wick tucked into your deck, or tails just long enough to touch the deck?
I can get 20-30 hits no problem before re-dripping.
Single or dual coil? In single coil mode, I use 15 watts, approximately what you've got. I leave long-ish tails, from the coil to the opposite wall, thinned down significantly the further from the coil they are. I am using rayon.
It's hard to see in the pic, but those wicks are swimming.
I used to drip gingerly, but just decided to go for it one day. I swear this little thing holds more than my magma!
Single or dual coil? In single coil mode, I use 15 watts, approximately what you've got. I leave long-ish tails, from the coil to the opposite wall, thinned down significantly the further from the coil they are. I am using rayon.
It's hard to see in the pic, but those wicks are swimming.
I used to drip gingerly, but just decided to go for it one day. I swear this little thing holds more than my magma!
I think you guys were right about too much cotton.. I took it out and the part where the coil touches is dark brown 
I put half the amount of cotton in and it seems to be holding up really well! I also put it on my SVD and am vaping at 11watts. Thank you guys!
God I love this forum.
I put half the amount of cotton in and it seems to be holding up really well! I also put it on my SVD and am vaping at 11watts. Thank you guys! God I love this forum.
You could always get a REO
I'm glad someone else said it, cause I sure was thinking that but trying to refrain from enabling.
I can't figure out what an REO is.. *embarrassed
No worries.
It's a mod with a hole in the bottom of the atomizer (called a bottom fed atty), with a 6ml bottle of juice and battery in it. It performs just like a dripper and when you need more juice, you squeeze the bottle. The juice goes up through a tube then the hole in the atty and wets your wicks. All the fun of dripping with none of the hassle.
reosmods.com
Only the greatest bottom up dripping mod of vaping awesomness!!!
Onboard juice bottle bottomfed atty! Cant be beat!!
Sent from my Atari 2600 using Tapatalk
This is an REO grand. 18650 bottom fed mechanical mod. No need to drip just squeeze the bottle and your wick becomes saturated. (This is not my REO just found it on google images)
I vape my RDAs at .21 ohm on mech mods and I get way more than 2 or 3 hits before re-dripping. OP, you don't have your coils wicked correctly.
I'm vaping at .26 ohms and I can take 30-40 hits (5+ seconds) before I need to drip again... This is in a Mutation X V2
No worries.
It's a mod with a hole in the bottom of the atomizer (called a bottom fed atty), with a 6ml bottle of juice and battery in it. It performs just like a dripper and when you need more juice, you squeeze the bottle. The juice goes up through a tube then the hole in the atty and wets your wicks. All the fun of dripping with none of the hassle.
reosmods.com
Oh dear god I thought I was done spending money on vaping
that's the best thing I've ever heard of.
Oh dear god I thought I was done spending money on vaping
They are amazing little devices. Only problem is you have to buy bottom feed ready RDA's. The REOmizer 2 is a very popular one. There is somebody on the forums who does custom bottom feed mods. I know Angelcigs has a Zenith v3 which is bottom feed ready. If you look into getting a new mod this is one to look at. Only thing is you need to know a lot more about battery safety (if you don't know about mech mods, shorts, etc) because this is a MECHANICAL mod. No regulating, only safety is the hot spring I believe.
Oh dear god I thought I was done spending money on vaping
If you're interested, stop in the REO forum here at ECF, do some reading and ask any questions you like - lots of very helpful folks there:
Reos Mods
The next mod I was going to get was the Vapor Shark DNA 30, but this is now at the top of my list. I will definitely do more research on battery safety before purchasing of course!
- Status
Similar threads
