iClear 30 top coil

[Lbx!]

Some one stated that the iClear30 would not wick well or vape well once it got low. I can not find that thread but I would like to post 2 photos that I took tonight of my tank. I am still getting full clouds of vapor and while I do have to rotate the tank now and again I am not getting dry hits at all. and Obviously these are just my experiences but they have been consistent for the last three weeks.

 

[Lbx!]

I would like to mention that this was 100% VG legend from Heather's Heavenly Vapes and had been allowed to sit for 45 minutes in a warm kitchen before I took the photographs. The wicks are still wet, I could have picked it up and vaped it with out any concerns.

 

[State O' Flux]

Like you, I've never had a problem with iClear 30s - not even ones where I've gone to the trouble of building my own coils and wicks.
I suspect that those with wicking issues were perhaps having other issues as well... a leak for example.
If the balance of pressure is disturbed (and I can elaborate on this here), it might contribute to wicking issues with a close to empty tank. Most of the "complaints" I see are aimed at leaking... with, I suspect, the majority of those due to over tightening.

 

[Craig_B]

Does yours draw really hard? I'm vaping cell block four, taste is great but the draw is super tight. Am I doing something wrong? My APV is a MVP 2. Thanks!

 

[State O' Flux]

There are ways of providing a more airy draw for both the iClear and iTaste.

 

[Craig_B]

Thank you much!!

 

[HawaiiVPR]

Same here, never experienced dry hits on the iclear30, even when there was barely any juice left in the tank. I had more gurgling issues in the beginning, but that was due to user error when I first started using it and filling it past the 3.0Ml line.

 

[erikbal]

I've also never had a single dry or burnt hit on either my 30 or 30s. I like them both but the 30s definitely gets more use.

Sent from my DROID4 using Tapatalk