igo-l fasttech
- Thread starter eleethesontai
- Start date
- th_trl_thread_readers 0
- Status
eleethesontai:10726758 said:
Dunno if its a clone of a clone or what, but I can tell you its a solid rda and well made. The o-rings fit snuggly and the top cap is sturdy steel. Broke two drill bits trying to drill through it. Got it wrapped in a dual coil with cotton wicks and it rocks. The drip tip alone is worth it.
I would assume that it is However it work's fantastic especially when you have the hole drilled out to 1/16
Besides with the bigger hole the only modification needed (which is needed with original as well)
there's nothing else needed its a basic design they cant mess it up
the quality of vape comes from your coil build
there's nothing else needed its a basic design they cant mess it up
the quality of vape comes from your coil build
I wouldn't worry about it. I bought one from a local supplier and my air hole was so low on the cover that it was partially covered by the base rim. I would have drilled it bigger anyways so that didn't bother me. This puppy is so basic if the parts don't fall apart, it will work just fine.
just bought the igo w for 13 bucks today. a little better build than the l model.. from a USA site also..Dragonfly ecigs
I just ordered an IGO-W from them and I'll compare it to the Youde IGO-W I have. Has anyone inspected the posts to see if they are in fact stainless steel or if it's plated brass? That would be the only deal breaker on the Fasttech version for me.
- Status
Similar threads
