igo-w smells like old juice even after rebuild. help please!
- Thread starter ford12acing
- Start date
- th_trl_thread_readers 0
- Status
The Chinese tend to use lower grades of plastic for insulators (and rubber for o-rings)... and if the juice you use is a little "aggressive"... it can eat into and stay with the parts, long after you've used it.
Might want to try warm to hot water and baking soda, or same again, with white vinegar.
Could try washing with dish soap then boiling it. If nothing works, just use it with different juice for a while then it will smell like that one. Usually a quick rinse in hot water is enough to prevent it from tasting like the last juice.
yup. boil the metal. i would use baking soda over dish soap, but either is probably fine. just make sure you boil it long enough and rinse afterward.
Lots of juice will get inside of the screw posts.
Take the screws out and clean them.
Then clean inside of the posts.
I use a 1ml syringe with a fine tip and inject water inside of the posts to clean them out.
Had to do this after vaping a melon mix.
Also absinthe flavor seems to really hang around.
Other than that I use hot tap water and dish soap on a toothbrush and scrub everything down good and rinse well.
Take the screws out and clean them.
Then clean inside of the posts.
I use a 1ml syringe with a fine tip and inject water inside of the posts to clean them out.
Had to do this after vaping a melon mix.
Also absinthe flavor seems to really hang around.
Other than that I use hot tap water and dish soap on a toothbrush and scrub everything down good and rinse well.
Is it a clone or a real Youde Igo-W? I've never had that issue with my clone Igo-L or my real Igo-W. I'd remove the screws like savageman suggested and run it under HOT water for a while just to make sure there is no residual juice.
- Status
