Innokin iTaste MVP 2 with Innokin i30 3mL Dual Coil Clearomizer at 1.8 Ohms - proper voltage and wattage settings?

[ArchieCrisis]

Greetings all! Long time vaper, first post here.

I just upgraded my set-up to the above mentioned (innokin iTaste MVP 2 with innokin i30 3mL Dual Coil Clearomizer at 1.8 Ohms).

As I'm new to the whole VV/VW thing, I'm just wondering what the lowest and highest settings for the voltage and wattage are? Like how low can I go and still get a good hit, and how high can I go without worrying about frying the coil?

Thanks and happy vaping

-Archie




Sent from my iPad using Tapatalk

 

[Mrdaputer]

Long story short you are either in vv or vw not both. Start out low vv and keep bumping it up a little till it taste the best to you. If it starts tasting burnt back it down some. Different juices will have different settings.

 

[SunshinePete]

The proper setting is what suits you in terms of taste and vapour volume. I don't think the MVP is going to fry a coil as long as you keep it wet.

 

[ArchieCrisis]

Thanks all!

I'm already LOVING this set up over my old Kanger EVOD! The flavour is SO. Uh more present and the hits are PERFECT every single time!

I actually bought this device after seeing it recommended time and again on here, and you can add my name to the list of enthusiastic recommenders!


Sent from my iPad using Tapatalk

 

[ArchieCrisis]

3.7 Volts and 7.0 Watts seems to be the "sweet spot" if anyone in wanting to use this thread for reference.


Sent from my iPad using Tapatalk

 

[ArchieCrisis]

Obligatory post 4


Sent from my iPad using Tapatalk

 

[ArchieCrisis]

Obligatory post 5! Yay!


Sent from my iPad using Tapatalk

 

[Miguel Miranda]

I like to use my iclear 30b with 2.5ohm in 7-10 wats. Usually 8

 

[subiesltvb]

a good middle all day vape that work on 1.5 to 2.1 is vv 4-4.5 and then vw is 7-8 especially with medium thick liquids

 

[ArchieCrisis]

Thanks again all!

I seem to have found a good, comfortable sweet spot.

I can't believe how much better this kit is than the EVOD I used to have. Makes me wish I had just bought the MVP 2 to start with. Makes me realize what I've been missing!

Next question though: I see a lot of hype on here about the Aspire Nautalis with the BVC coils. Compared to the iClear 30 that the MVP 2 comes with, is the difference noticeable or not really. I don't really want to drop $30 on a clearo if the one I have will do just fine...


Sent from my iPad using Tapatalk

 

[lovekillsfear]

love my mvp 2/ have found that i use the vw setting mostly. For dual bottom coils i use 6.5/7.0 watts mostly.

 

[ArchieCrisis]

Question:

The ohm reader on the thing is reading 6.7 now?!

What's going on?? Did I fry my coil? :-/


Sent from my iPad using Tapatalk

 

[Mrdaputer]

Question:

The ohm reader on the thing is reading 6.7 now?!

What's going on?? Did I fry my coil? :-/


Sent from my iPad using Tapatalk

Not sure if you figured out what's going on. I have never had that high of reading. If you fried your coil to would be open and you would see non. Is it still vaping ok?

 

[ArchieCrisis]

My Aspire Nautalis came in today.

Ya, I see what the hype is about with this combo.

.......N what a clean, tight vape!

Currently puffing on Divine Fog Caramel 18mg. SO GOOD!

Just ordered a Dr Who TARDIS skin for the MVP too, I couldn't resist ;-)