Hey folks!
Ive had a VMax for about 2 months now and aside from an F2 issue (that was fun figuring out) its been my workhorse as I experiment with other mods and tank/ato set ups.
The issue is, the volt meter ( function 4) is reading the batteries backwards!
as the voltage in the batteries drops, the reading rises!
I noticed it with the stock batteries; in the morning I had hit it, it flashed the voltage then reset the board. tried it again, same thing.
swapped out the batteries and it fires fine but the volts read 7.7, so I watched it and I'll be damned but the reading was creeping up as I used it!
This morning its reading 8.2 and the batteries are dead. swapped them out and its reading 7.7 again but otherwise firing fine!
running a ProTank2 on it, no problems with that.
anyone else experienced this issue?
Thanks in advance!!
John
P.S. posting this here until I can clear my 5 posts

Ive had a VMax for about 2 months now and aside from an F2 issue (that was fun figuring out) its been my workhorse as I experiment with other mods and tank/ato set ups.
The issue is, the volt meter ( function 4) is reading the batteries backwards!
as the voltage in the batteries drops, the reading rises!
I noticed it with the stock batteries; in the morning I had hit it, it flashed the voltage then reset the board. tried it again, same thing.
swapped out the batteries and it fires fine but the volts read 7.7, so I watched it and I'll be damned but the reading was creeping up as I used it!
This morning its reading 8.2 and the batteries are dead. swapped them out and its reading 7.7 again but otherwise firing fine!
running a ProTank2 on it, no problems with that.
anyone else experienced this issue?
Thanks in advance!!
John
P.S. posting this here until I can clear my 5 posts
