IPV D2 announced.
- Thread starter Completely Average
- Start date
- th_trl_thread_readers 0
- Status
Mine is also estimated to come on the 12th. So finally almost here. Only like a month late lol
Probably just like production. To many orders, not enough product.
No doubt Vendors will be upset by the missing sleeves since they are supposed to be included.
Very doubtful P4Y will care either way.
No doubt Vendors will be upset by the missing sleeves since they are supposed to be included.
Very doubtful P4Y will care either way.
Well that is no bueno. I hope mine comes with one but if not it won't be the end of the world more than likely I won't use it much if at all. My VS is always without.
if it doesnt, sweet-vapes.com is getting 10 colors in soon i believe IPV D2 Silicone Case - Silicone Skins - Accessories
I'm still on the fence about this mod, but in case anyone is looking for one I got an email from Code-3 that they have them in stock for $54.99 with a Samsung battery and free shipping. No info in the listing as to whether it comes with a sleeve.
Pioneer IPV D2 Box Mod + Free Samsung 30Q Battery! - Code-3 Vapor
Pioneer IPV D2 Box Mod + Free Samsung 30Q Battery! - Code-3 Vapor
Finally got the output numbers.
1a to 25a Max.
Samsung R25 batteries should work fine for most users.
Concerned users should consider Sony VTC4's
1a to 25a Max.
Samsung R25 batteries should work fine for most users.
Concerned users should consider Sony VTC4's
Out is not = to in. A Samsung 25R can't do 75W (safely/within spec) all the way down to the d2's cut off. Need at least 24A to cover the 75W. The 25R's are good to about 64W @cutoff.
Freshly charged, yes. Depleted (below 3.8V), No.
Something to keep in mind when telling folks what cells to use.
Edit: in fact, the d2 spec sheet says 30A minimum input.
something interesting.... i switched into Power mode with my Ti coil and i noticed that the resistance was jumping around after setting it. i swtiched to an atty with a kanthal coil and the resistance stays put. So even if you want to use a Ti coil in power mode it keeps showing the current resistance rather than the set resistance, which then make the voltage look really high
If it's like the Sigelei 75 tc it won't fire when the sammies get to 3.6 and you're at or above 50 watts.
Don't think you are supposed to run nickel and titanium outside of tc mode. I heard it can be dangerous. Something to do with it being like nonresistance wire
What part of fine {for most} do you not understand?
Most will NOT consistently vape at 75w
Or do you just like busting everyone attempting to give a little recommendation?
Again - Concerned users,( or those wishing to stress their mod to the Max continuously) a VTC4 or similar is a logical choice.............considering there are few options available in an 18650
If you have found the Chip specs on YiHi, I would be interested in a link. I have yet to find the chip listed.
* Note:
You also seem to not know, or ignore that the big interest in this mod is TC control which is limited to 50J
Last edited:
- Status
Similar threads
