ipv2 sketchy ohm reading

[TCarlson03]

I just wanted to share a little something here as I read many people are having a similar issue as me. I have a IPV2 and the ohms were jumping all over the place and it took me a while to track this down but it came out to be no issue with my tanks at all. In fact it is a connectivity issue with 510 connector to the box itself. I have tried soldering it twice now and it fixes the problem for a short time, probably due to my sub standard soldering ability. I will probably have to find a much better solderer to run me a wire from the screw where the ground wire is soldered on to the bottom side of the 510 to correctly fix the problem.

 

[Warpigs]

Welcome to ECF! I'm lucky my Silver Bullets have not given me any problems. /knocks on wood.

 

[TCarlson03]

Ya. Other than that little irritating quirk I love my ipv. Started with a ego nonadjustable, went to a spinner, then a Vamo, Them an I stick, now the ipv. The IPV is by far my favorite!!