is anyone else having wicking issues with the kayfun v4 clone (fasttech version A)?

Status
Not open for further replies.

thatJuice

Full Member
Nov 2, 2013
61
16
USA
i have looked this thing over and over and it looks like all the parts and 0-rings are here. everything is screwing on smooth and not wobbling or seizingg up. 1.4ohm single coil build using 28g around a 2.4mm screwdriver. wicked with organic cotton balls, japanese cotton or rayon.. i have tried a little bit of cotton, more than enough cotton, tapered end cotton, layed over the holes, flared at the bottom, barely touching the deck, halfway in each hole .. and all the same problem.. i fill the tank and open up juice control, watch the bubbles float to the top and vape but no air bubbles come up while i'm vaping..then after a few pulls, i start getting dry hits.. if i suck really hard and quick, air bubbles will release for another few pulls then when i suck quick and hard, nothing.. and more dry hits..


any help would be appreciated.
 

drunkenbatman

Ultra Member
ECF Veteran
Verified Member
Jan 26, 2014
1,340
1,271
It's windy, USA
Hey mate, found you wandering far in the weeds -- and unfortunately I don't have a v4, and the only thing I have in my head is to have the juice flow fully open then tighten the airflow down. It may also be you're blowing too many watts for it to wick, but I know you aren't the only one having an issue.

If someone doesn't catch you on the bump, you might check out and/or post in this thread:

http://www.e-cigarette-forum.com/forum/rta/634516-attack-kayfun-v4-clones.html

You'll probably want to have the SKU of the item you ordered rather than "version A" and such. :)
 
Status
Not open for further replies.

Users who are viewing this thread