Is my iTaste mvp 2 dead? :(

[Papillon61]

I was using it this morning and everything was fine. This evening I turned it on but every atty I put on it reads "non" or A0.0. The atties work fine on everything else with no problem. I haven't tried to fire the atties on the iTaste because unless I'm perfectly happy that the reading is what it should be I don't do that.

I've only had it since March 25 and I use it in rotation with other mods.

What could be the problem?

 

[Robino1]

{{{{{{ Pap }}}}}} you certainly are going through some trying times with your vape

I don't know the answer... Just wated to give ya a hug and virtual support.

 

[Susan~S]

Sounds like the center pin of the battery is not making a connection with the atomizer of the clearomizer/tank. This usually occurs from over-tightening the tank onto the battery connector. Just make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.

Center Pin Issue - Fixing a non firing eGo battery

 

[Papillon61]

Thanks Robin.

 

[Papillon61]

Sounds like the center pin of the battery is not making a connection with the atomizer of the clearomizer/tank. This usually occurs from over-tightening the tank onto the battery connector. Just make sure that if you use something conductive (metal) to pry up on the center pin that you do NOT hit the fire button while you are working on the battery. Or better yet, turn off the battery.

Center Pin Issue - Fixing a non firing eGo battery

Thanks - I'll have a look at that link. I'm really not techy at all, but I'll give it a go. The mod does work - it's just not reading the atties.

 

[Baditude]

90% sure your center pin got pushed into your MVP, from over-tightening your tank. It's quite common with the MVP. I usually had to adjust my MVP's center pin about once a week. See the link in Susan's post. I used either a micro screwdriver or the nail file of my nail clippers.

 

[bluecat]

Also you may have to clean the thread of MVP. When mine does the 0.00 thing, it is either

1) center pin pushed down

2) liquid got in the threads. - I usually cleaned with a cotton swab and alcohol. - Just don;t push down on the center pin when cleaning.

 

[Papillon61]

Thanks all - it worked!! Papillon is happy again!