Is my twist dead?

[disturbed1]

I charged my twist today no big deal. Until I went to use it again.I screwed a stardust to it and if flashed 3 times and stopped working. put another stardust on and did the same thing. with nothing on it-it seems to work just fine. I tried lifting the pin on it, still the same. Anyone have any thoughts?

update I tried a carto on it, pushed the button and got nothing,pushed it again and got 3 blinks,pushed it again and it worked. It will do that every time now so far

 

[Daniel13]

3 blinks means there is a short somewhere, could also be reading too low of a resistance maybe you didn't screw them on tight enough or maybe even too tight, leaking juice might cause that as well. that's about all i can think of

 

[disturbed1]

I played with it a bit this morning. Its starting to blink 3 times with nothing on it.

 

[the.quiet.rider]

What voltage do you have it set to?? I've noticed that even though it doesn't have an ohm reader, it seems to cut off if you're attempting to over power your carto, as if it reads it as a short somewhere. Are your stardusts 2.1-2.4ohm?

 

[disturbed1]

What voltage do you have it set to?? I've noticed that even though it doesn't have an ohm reader, it seems to cut off if you're attempting to over power your carto, as if it reads it as a short somewhere. Are your stardusts 2.1-2.4ohm?

there the same ones Iv always used. It doesn't mater what I put on its the same

 

[Shub]

I had this problem and one of the wires was disconnected from the inside

 

[r77r7r]

I think there's a youtube vid on fixing them.?

 

[JUDGMENT AFFIRMED]

Hi disturbed1,
I have a Kgo doing that when it chooses too. It only works right when it wants too. This has been going on for 4 weeks. I have enough stuff to know something wrong with the battery. Short, maybe? Took it apart, everything looked ok to me, except all the white gunk they put on the circuit board. Put it back together and its working good now for 4 days. Don't throw away to quick.

 

[disturbed1]

I got it all set. There was a soos wire got it soldered and it works

 

[Kent C]

Chances are it's the center post in the stardust....

I've had the same problem... see this recent post #14

http://www.e-cigarette-forum.com/fo...-not-fire-stardust-anymore-2.html#post8024286

So if you think you're Joye eGo-c batt (any type that has the new protection) is dead either try the 5 clicks or put it back on the charger for a minute and try again.