Issue with eVic fire button

Status
Not open for further replies.

OlDogNewTricks

Ultra Member
ECF Veteran
Aug 21, 2013
1,061
757
Venice, FL
I didn't see a sub-forum for the eVic, so I am posting here. I have had my eVic for about a month and it has been working great. Yesterday, when I pressed the fire button, it clicked in and stayed in further than it has before. It used to stick out about 1/4 inch and it is now about 1/8 inch. It is not fireing when I am not pressing the button. Unfortunately, when I put it on to charge last night (it was at about 25% charged) and awoke this morning, it is only at about 34% charge after about 9 hours charging. I have written the vendor but am wondering if anyone has had a similar issue.

Thanks for your help.
 

crxess

Grumpy Ole Man
ECF Veteran
Verified Member
Sep 20, 2012
24,438
46,126
71
Williamsport Md
No, and No.
Head is sealed and not designed to separate intentionally.
The switch is directly on a circuit board. You could try a good alcohol wipe and fiddle around it with a pin, but it sounds like it has been crushed.
eVic9b.jpg
 
Status
Not open for further replies.

Users who are viewing this thread