Issues with Kanger Aero V2

[Jh270]

Hoping all you experienced folks can help out a bit. I recently purchased a Vamo V6, and have a Kanger Aero V2. 1.8 Ohm and have played with the wattage from down to about 6 up to 13, and 10 seems to be the best, but the issue is, the vapor production is not consistent. Sometimes it will produce nice thick clouds, other it's like one of them cheapo things that look like a cigarette. I have an ego-c twist with a Kanger T3S, and it consistently produces thick vapor, and it's set at ~3.9 Volts. Works much better than the Aero

What gives with this thing?. And, yea, with the Aero, it behaves this way whether it's a new atomizer, or one that's been in a week.

Any help would be appreciated.

Thanks all

 

[Margate69]

Start by checking and cleaning all connections with alcohol. I recommend whiskey. I mean vodka works, it all depends on what you drink really. Cause who doesn't like to drink and vape?

 

[Jh270]

Start by checking and cleaning all connections with alcohol. I recommend whiskey. I mean vodka works, it all depends on what you drink really. Cause who doesn't like to drink and vape?

Ok. Well I used 100 proof moonshine, so that worked fine, but I didn't get much 'gunk' out of anything. (I just bought it ~week or so ago. Anyway, it's still vaping the same.

Thanks for the info

 

[Margate69]

Any difference in taste? It may not be wicking the juice properly. One or two good hits, a third dry hit.

 

[EBates]

Does the T3S work Ok on the Vamo?

 

[Jh270]

Any difference in taste? It may not be wicking the juice properly. One or two good hits, a third dry hit.

I didn't notice any difference in taste, but the one to two good pulls, then some bad ones..that's what it's been doing this whole time. I switched out the atomizer that shipped with it with one from a pack I bought (about three days ago) and it worked great for a few hours, then went back to the way it was working with the first atomizer.

thanks,

 

[Margate69]

Sounds like a problem with juice flowing to the coil. Add a couple drops of water (seriously, a little goes a long way) to a full tank. It will usually fix the problem.

 

[Jh270]

Sounds like a problem with juice flowing to the coil. Add a couple drops of water (seriously, a little goes a long way) to a full tank. It will usually fix the problem.

Ok, tried that, and nadda. I mean, it seems like it's just the tank itself. I'm wondering if there's a better one. I know Kanger has good reviews and whatnot, but it's T3S blows this aero away.