Vamo v2 issues

[iamgally]

Just picked up a Vamo v2 with a kangertech aero tank 3 days ago. I love this vape but I'm starting to have some issues with it. When i first picked it up it was fine and then I started to get a low load display. Not sure what it was I went to this forum but didn't really get a clear answer. I figured out if I just unscrew just a little it will work fine. Thats the first issue...

Second issue now is that the resistance used to be 2ohms. Now when I screw it in all the way it says 9.9 ohms and if I back it out a little it will read anywhere from 4 to 2.1.

Really confused on this whole deal and I'll admit I'm not a whole lot experienced. I searched a little on this site but didn't find much on this.

 

[Rickajho]

From what you are describing it sounds like you are screwing the tank on waaaay too tight. If you do that, you can force the center post on the 510 connector down into the VAMO - giving you a dead short - which is what a reading of 9.9 on the display would indicate. If you can't unscrew that tank from the VAMO with only one hand you are over tightening it.

 

[iamgally]

Not at all. I screw it on just enough so its tight but definetly not over tight. Like I said when I back it out a little it would work and be a consistent 2ohms until tonight and now it doesn't work at all

 

[iamgally]

fixed it. rickajho thanks for the input, it wasn't the tank that was too tight it was the atomizer